Nylon Joiner Tubing

Home/Wire/Nylon Joiner Tubing

Nylon Joiner Tubing

$1.75$6.95

In stock (can be backordered)

Clear, heat sensitive nylon tubing yardage to use for joining ends. Cut into approximately 1-1/8″ lengths. One yard makes roughly 32 pcs.

The tubing is 3/32″ or .0937 or 2.38mm

SKU: 5211nj Category: Tags: , ,

Description

Insert wire ends in joiner and overlap. Apply heat from heat gun or flame (but not directly in the flame), joiner will shrink to grip wire. The ends do not slip out. This Size joiner fits all gauge wire.

Wire will not stretch, so care must be taken to measure accurately. There are a couple of ways to join the ends of your wire. My favorite method is wrapping the ends with thread. Allow 2 inches overlap for this method. Using strong millinery thread, begin at one end of the overlapped wires and wrap tightly towards the other end of overlap. Add a dab of clear glue to each open end of wire at the overlaps. The most common stitches for securing wire to the edge of a brim are a buttonhole stitch for hand sewing and a wide zig-zag stitch when using a sewing machine. It is important to sew the wire to the edge, not on top or under the brim edge. The stitch width should be only the depth of the wire. If the stitch is too deep, the wire will slip away from the edge and can cause an uneven looking finish to the brim. See our FAQ section for more in depth instruction.

Additional information

Weight 0.01 lbs
Dimensions 4 × 4 × 1 in
Unit of Measure

,

Go to Top